Mini Frisbee Golf Pin

I saw one of these pins as a display at a store and ask how much and they said 150.00$. although it was made out of metal the one I decided to make works just as good. I did get a few ideas from a different instrucable that I would like to give credit too

Tools and Supplies

Supplies

10 inch fan

8 ft chains

3/4 inch pvc pipe

6ft 3-(3 ways 3/4" pvc connector)

quark 3/4 inch two way connector

4- 3/4 in end caps of legs


Tools

saw

pliers

screw driver

silver duct tape s

ilver spray paint

Assemble PVC STAND

FZ9QDDDHP0CRKFE.MEDIUM.jpg

cut the pvc into 4 six inch peices and 1 12 inch piece and connect the pieces into the connector pieces.

Make the Basket

F9H1A32HP0CRKFG.MEDIUM.jpg

the basket is made out of a 10 inch fan. I took the fan apart and had to pieces. I cut one of the sides so that it was flat for the top. I screwed this piece in a 1 ft piece of pvc pipe. i put a cork in the pvc to screw into. I cut the chain lengh in to 1 ft pieces. For the bottom of the basket i used the other have of the fan with the the sides that curve up and cut them to fit on the lids

Final